Monthly Archives: September, 2010

Using the NKC RGB LCD Shield with the FEZ Domino (Update)

Lately I’ve been doing some more work with the NKC RBG LCD Shield and the FEZ Domino. The biggest hurdle to getting the two to work together is the open collector outputs on the FEZ Domino at header pins 2 and 3. These cause the logic levels at the LCD chip select and reset to …

Continue reading

GPIO Timing On The FEZ Domino

As I mentioned in a previous post, I’ve been playing with the FEZ Domino board and the RGB LCD Shield distributed by NKC Electronics. This display uses a synchronous serial protocol similar to SPI but requires a fourth wire to indicate is a byte is a command or data. This fourth line can be implemented …

Continue reading

Using the NKC RGB LCD Shield with the FEZ Domino

With the popularity of the Arduino it’s only natural that development boards for other systems would be offered in the same form factor.  An advantage of this is it allows each system to take advantage of add-on boards developed for the other.  However, just because two boards share the same form-factor and pin-out, that doesn’t …

Continue reading

Tabula Candida

Doodles of a distracted historian

rtl-sdr.com

A blog about RTL-SDR (RTL2832) and cheap software defined radio

DuWayne's Place

Computers, Electronics, and Amateur Radio from KC3XM

QRP HomeBuilder - QRPHB -

Computers, Electronics, and Amateur Radio from KC3XM

Open Emitter

Computers, Electronics, and Amateur Radio from KC3XM

Ripples in the Ether

Emanations from Amateur Radio Station NT7S

m0xpd's 'Shack Nasties'

Computers, Electronics, and Amateur Radio from KC3XM